1. Measure the thermocouple's millivolt output.

2. A millivolt is one thousandth of a volt.

3. Standard switch entirely suitable for millivolt service on self - energized control circuits of gas fired heating installations.

4. DC millivolt table is commonly used measuring instruments, the use of digital manipulation can make a more intuitive, and fast response, is an ideal measurement tool millivolt range.

5. Among them, the DC millivolt table testing is often used in the experiment, the thermocouples used to measure the thermal resistance of such sensitive components of the small-signal detection.

6. The research also indicates that SD is millivolt voltage signal with slow variation.

7. DC millivolt millivolt level table for the accurate measurement of small signals, Used in experimental testing, production testing and maintenance of the use of.

8. In the present design, step inputs are restricted to a few tenths of millivolt.

9. ECG was monitored before and after coronary artery ligation, and after treatment at different time points. At the same time, the millivolt of ST and ST- T segment were measured.

10. Bi-directional, steady-state, and transient heat flow may be sensed quantitatively and displayed upon any standard millivolt recorder.

11. Where the volt is too large a unit, we use the millivolt or microvolt.

12. The 848T Wireless monitors up to four independently configurable RTD, thermocouple, ohm, millivolt and 4 – 20 mA inputs allowing users access to more temperature measurements without any signal wire.

13. Based on the daily experiences, several factors about the decrease of spectrometric millivolt values were studied, and several ways for solving this problem were also suggested.

13. Wish you can benefit from our online sentence dictionary and make progress day by day!

14. Plessey describes EPIC as essentially a very sensitive, contactless digital voltmeter capable of measuring millivolt changes in electric fields.

15. The voltage across RL1 is the picoammeter voltage burden, normally less than one millivolt, so the resulting current will be quite small.